[• 5 v2 Instructions / FAQ]

• 5 v2 Instructions / FAQ
• 3.x Instructions / FAQ
• RaspJAMMA Mini Manual
• RaspJAMMA 4-P Manual
• Mac Partitioning Guide
• Dipswitch Guide
• RaspJAMMA PCB Layout
• How to Fit your Raspberry Pi
• GPIO Wiring Guide
• Compatible ROMS List

I'm back online in the office but it's a bit shonky at the moment, might have to try extending the LAN rather than using WiFi.  Still a lot to sort out... (and where are my BNC RGB cables for the test bench...)

@Gsr94t did you sort it in the end?

@MarkOZLAD did you get any improvement out of FBNeo?

@PackingProtons did you get the voltage fixed up and are you up and running now?

@Flynn Lives thanks for helping people while I've been offline.

I recently installed this version to my RPI (last version was 3.7 I guess). Hooked to a jamma arcade cab with CRT. Now when trying to run a game this happens:

The menus run fine, only when trying to run a game the resolution is off. I didn't have this problem in the 3.7 version.

How to fix this?

What emulator is that running in?  And also, what system settings are you using? (defaults?)  I'll have to take a look.

If it's AdvMAME (MAME 106) it's likely you can fix the issue with the video menu in AdvMAMEs menus (tab or start+right while the game is running).

I will check. Thanks!

I haven't had the chance to try it. We rent out our downstairs periodically and there are people in atm so I don't have access to the arcade.